Step 8: Working with the Matrix.
Your matrix should now look similar to the matrix pictured below. There are several modes for each
transmitter and receiver that will help you setup your video matrix. To change a device’s mode, do the
following.
1.
Double-‐click on the Transmitter or Receiver.
2.
Click on the drop-‐menu to the right of the device’s name input box.
3.
Select the Desired Mode. In Host Play, or Local Play (explained below) you must also choose one of the
playlists.
The Various Modes for each device are as follows.
1.
Transmitter
A.
Host Play – Each transmitter has on-‐board memory for storing a various amount of still image
files. These can be used to display a slideshow to multiple receivers in a similar fashion to Live
Play. This will turn off the attached video sources video, and begin playing back the slideshow
B.
Live Play – This is the video coming from the attached device
C.
EmCast – An Emergency Messaging system that can send message to all receivers in the
network.
2.
Receivers
A.
Local Play – The same thing as host play, but is only available on the receiver
B.
Live Play – Plays the live stream coming from a transmitter.
Changing the Matrix
1.
Start by attaching a video source to an available Transmitter.
2.
Verify your transmitter is in Live Play Mode
3.
Verify your desired receivers are in live play mode as well.
4.
Using the Radio Buttons, click the cross-‐point for the Transmitter/Receiver combination – as shown
below.
Summary of Contents for ATR-201
Page 3: ...Application Examples ...
