SVERO 1 SA, User Instructions, Page: 8 / 48

8
X X Load hook latch Replace hook latch and/or
spring if function impaired.
X X Load hook Check that the hook is not worn
or deformed and that it is
securely attached to the rope.
X X Control device Test the function of control
buttons and emergency stop.
Correct direction of movement
and stop.
X X Control device No visible damage or cracks to
casing and cable.
X Control device Contact screws on conductors
must be well tightened.
X X Brake Function testing.
X
X
Complete winch Condition and function.
Test with 10 % overload.
X Gears Condition and function. Check
gears internally for damage or
wear to wheels and shafts. The
gear housing must contain
plenty of grease. Top up or
replace as necessary. Mobilux
EP2, Shell Unedo 2 or similar.
*) See rope fixing under “Replacing wire rope”, Page 6.
Troubleshooting
Faults and probable causes Remedies
Winch will not work
Emergency stop pressed.
Fault in electrical connection.
Reset the emergency stop. Turn clockwise or pull
out.
Check fuses and cables.
Buzzing noise but will not start.
Phase loss in three-phase
winch. Check fuses and voltage in all three conductors.
Winch unable to pull the load.
Load bolted down or jammed.
Overload.
Eliminate the hindrance.
Reduce the load.
Brake not working