ENG
5
BTR2-10
2.1 Multimedia Speaker System
Remote control battery installation
•
Open the battery compartment on the back of the remote control.
•
Put in the CR2025 battery (included).
•
Close the battery compartment.
Notes:
• Use the remote control at an angle no more than 30°, no more than 7 meters away.
• Direct the remote control at the IR receiver display on the subwoofer.
• If the remote control does not work, check the battery or replace the discharged battery
with a new one.
• Remove the battery from the remote control if you don’t intend to use it for a long time
(more than a week).
5. PREPARATION AND OPERATION
Speaker placement
•
Place the speakers symmetrically to the listener at least one meter away. The subwoofer emits
non-directional sound, therefore it can be located in any place of the room where it sounds the best.
•
Place MSS far away from monitors and TV sets, as insigni
fi
cant image distortion in these
supersensitive devices is possible.
MSS
с
onnecting and control
BTR2-10 2.1
Multimedia Speaker System (MSS) can be attached to virtually any audio source (see
Fig. 4).
•
Before connecting, make sure that the MSS is unplugged. Then, connect the subwoofer to the
satellites using the audio cables supplied (see Fig. 4), use correct polarity.
•
To connect the speakers to a CD / DVD-player, TV, PC sound card, etc., use the 2RCA to 2RCA stereo
signal cable. Be sure to connect the left and right channels. Insert the left RCA-jacks into left ports of
the ampli
fi
er (usually white), and the right RCA-jacks — into right ports of the ampli
fi
er (usually red).
Note. The accuracy and reliability of the connection of cables directly affects sound
quality. Check for absence of contact between bared wires and metal parts of the
equipment.
Installation and connection of antennas
FM antenna connection
•
Insert the included room FM antenna into FM ANT terminal on the subwoofer rear panel, as
shown in the diagram. Install the FM antenna in such a way that reception quality is satisfactory, and
then
fi
x the position of the antenna.
Note. External 75 Ohm FM antenna should be used for buildings with weak FM signal.
Typically, a three-element antenna is enough, but in areas with weak FM signal it is
recommended that you use an FM antenna with 5 or more elements.
