MENU SETTINGS
Alarm Out Time
When you select ALARM OUT TIME , the number indicates how long
(in seconds) the alarm lasts after the sensor detected the motion signal.
If you set CONT, the alarm will keep continuous when sensor detected the
motion signal.
If you set OFF , the alarm will not function when sensor detected the motion
signal.
Sensor Type Setup
When you select SENSOR TYPE SETUP, you can select NOT INSTALLED,
NORMAL OPEN type or NORMAL - CLOSE type sensor to make setting for
each channel.
In NORMAL-OPEN mode, if the connecting cable from sensor to DVR is cut
off by an intruder, the sensor recording will stop.
In NORMAL-CLOSE mode, if the cable connected to the sensor through DVR
is cut off by an intruder, the sensor recording will start.
NETWORK SETUP
(NOTE: THE NETWORK SETUP MENU IS USED ONLY FOR THE SYSTEM WITH OPTIONAL
LAN INTERFACE. IF YOUR SYSTEM WITH BUILT-IN LAN INTERFACE, PLEASE REFER TO
NETWORK MENU.)
CAUTION:
RESET (Initialization): To make the system reset, press ";" button 5 times in the nor-
mal view mode. Be aware that all the information (Including password) will be
lost. After resetting, the password will be set as the default value (111111).
*After above setting process, press [MENU] button to go back to [MAIN MENU],
then you can select other item for setting or press [MENU] button again to go
back to View screen for recording function or operate the other function.
NETWORK SETUP
> ACCEPT CLIENT
[YES]
MAC ADDRESS
30.22.24.23.25.26
IP ADDRESS
192.168.001.090
SUBNET MASK
255.255.255.000
GATEWAY
192.168.991.245
PRESS (< , >) THEN (SELECT)
PRESS (MENU) TO EXIT
