Suzuki Nexa S-CROSS series 2015, Owner'S Manual & Service Booklet

Page: 162 / 288

27+(5&21752/6$1'(48,30(17
06(
$LULQWDNHVHOHFWRU
61MM0A020
This selector is used to select the following
modes.
)UHVK$LUI
When this mode is selected, the indicator
light will go off and outside air is circulated
inside the cabin.
5HFLUFXODWHG$LUJ
When this mode is selected, the indicator
light will come on, outside air is shut out and
inside air is recirculated. This mode is suit-
able when driving through dusty or polluted
air such as in a tunnel, or when attempting
to quickly cool down the interior.
The "FRESH AIR" position (f) and RECIR-
CULATED AIR air position (g) are switched
alternately each time the air intake selector
is pushed.
NOTE:
If you select the RECIRCULATED AIR posi-
tion (g) for an extended period of time, the
air in the vehicle can become contaminated.
Therefore, you should occasionally select
the “FRESH AIR” position (f).
$LUFRQGLWLRQLQJVZLWFK
To turn on the air conditioning system, set
the blower speed selector to the desired
blower speed position and push in the air
conditioning switch (5). With the air condi-
tioning switch operation, a indicator light will
come on when the air conditioning system
is on. To turn off the air conditioning system,
push the air conditioning switch again.
During operation of the air conditioner, you
may notice slight changes in engine speed.
These changes are normal, the system is
designed so that the compressor turns on
or off to maintain the desired temperature.
Less operation of the compressor results
in better fuel economy.
6\VWHP2SHUDWLQJ,QVWUXFWLRQV
1DWXUDOYHQWLODWLRQ
Select the VENTILATION position (a) and
“FRESH AIR” position (f), the temperature
selector to the desired temperature posi-
tion, and turn off the blower. Fresh air will
flow through the vehicle during driving.
)RUFHGYHQWLODWLRQ
The control settings are the same as for
natural ventilation except turning the
blower speed selector to turn on the
blower.
1RUPDOKHDWLQJXVLQJRXWVLGHDLU
Select the HEAT position (c) and “FRESH
AIR” position (f), the temperature selector
to the desired temperature position and the
blower speed selector to the desired
blower speed position. Setting the blower
speed selector to a higher blower speed
position increases heating efficiency.
4XLFNKHDWLQJXVLQJUHFLUFXODWHGDLU
The control settings are the same as for
normal heating except selecting the
RECIRCULATED AIR air position (g). If
you use this heating method for an
extended period of time, the air in the vehi-
cle can become contaminated and the win-
dows can become misty. Therefore, use
this method only for quick heating and
change to the normal heating method as
soon as possible.
(f) (g)