Suzuki Nexa S-CROSS series 2015, Owner'S Manual & Service Booklet

Page: 37 / 288

%()25('5,9,1*
06(
then push the unlock end (6) (backward
end). Repeat this operation 3 times.
Every time you perform the series of the
above steps, the state of the security sys-
tem changes from the currently selected
one to the other. You can check whether
the system is enabled or disabled by the
number of interior buzzer beeps at the end
of the procedure as follows.
• If you cannot complete the operations in
step 3) and 4) within 15 seconds cor-
rectly, the state of the security system
will not change and the interior buzzer
does not beep. Perform the procedure
again from the beginning.
NOTE:
You can also switch the security system
from the enabled state to the disabled
state, and vice versa, via the setting mode
of the information display. For details on
how to use the information display, refer to
“Information Display” in this section.
:LQGRZV
(OHFWULF:LQGRZ&RQWUROV
The electric windows can only be operated
when the ignition switch is in the “ON”
position or the ignition mode is ON.
'ULYHU¶VVLGH
64MS025
The driver’s door has a switch (1) to oper-
ate the driver’s window, and a switch (2) to
operate the front passenger’s window or
there are switches (3), (4), to operate the
rear left and right passenger windows,
respectively.
3DVVHQJHU¶VGRRU
64MS026
The passenger’s door has a switch (5) to
operate the passenger’s window.
81A009
To open a window, push the top part of the
switch and to close the window lift up the
top part of the switch.
System state Number of beeps
Disabled
(Mode A)
Once
Enabled
(Mode D)
4 times
(1)
(2)
(4)
(3)
(;$03/(
(5)
(;$03/(
CLOSE
OPEN