15
Using multi circuit tester, measure the battery volt-
age. The tester should indicate more than 12.5–12.6
V (DC) as shown in the Fig. If the battery voltage is
lower than the specification, charge the battery with a
battery charger.
Recharging time:
6.0 A for one hour or 1.4 A for 5–10 hours
After filling the battery electrolyte or recharging bat-
tery, install the battery in the vehicle as follows.
"
1. Install battery into place.
2. First connect the
+
+
+
+
lead to the
+
+
+
+
positive terminal
of the battery.
3. Cover the
+
+
+
+
terminal with rubber boot.
4. Connect the
-
-
-
-
lead to the
-
-
-
-
negative terminal of
the battery.
A:
+
lead
B:
-
lead
C: Rubber boot
Reinstall the bracket.
A: Bracket
B: Bolt
NOTE:
Initial charging for a new battery is recom-
mended if two years have elapsed since the
date of manufacture.
When attaching the wiring harness battery
leads to the battery terminals, observe the cor-
rect polarity.
NOTE:
The terminal bolts and nuts are attached to the
battery.
Summary of Contents for LT-A400FK3
