Suzuki drz 400E, Service Manual

Page: 329 / 334

11-26 DR-Z400/EK2 (’02-MODEL)
• Apply THREAD LOCK SUPER “1303” to the seat rail lower
mounting bolt
4
.
99000-32030: THREAD LOCK SUPER “1303”
• Tighten the seat rail upper mounting nut
3
and lower mount-
ing bolts
4
to the specified torque.
Seat rail upper mounting nut:
35 N·m (3.5 kgf-m, 25.5 lb-ft)
Seat rail lower mounting bolt:
35 N·m (3.5 kgf-m, 25.5 lb-ft)
DAMPING FORCE ADJUSTMENT
After installing the rear suspension, adjust the rebound and com-
pression damping force as follows.
NOTE:
Do not turn the adjust screws more than the given position or the
adjuster may be damaged.
REBOUND DAMPING FORCE ADJUSTMENT
Fully turn the damping force adjuster
1
clockwise. It is at stiffest
position and turn it out to standard position.
Standard setting position: 13 clicks out
COMPRESSION DAMPING FORCE ADJUSTMENT
Compression damping force could be adjusted in two stage by
turning the two adjusters.
High speed damping force
Fully turn the high speed damping force adjuster
2
clockwise. It
is at stiffest position and turn it out to standard position.
Low speed damping force
Fully turn the low speed damping force adjuster
3
clockwise. It
is at stiffest position and turn it out to standard position.
Standard setting position
High speed damping: 1
turn out
Low speed damping: 10 clicks out