“ON” and “OFF” positions, and shall disconnect all
current carrying conductors simultaneously.
Prior to installing the dehumidifier, apply power to the
unit and verify the fan and compressor are operating
normally.
The power supply cord contains a ground fault circuit
interrupter (GFCI) that senses damage to the power
cord. To test your power supply cord, do the following:
1. Plug in the Surna Dehumidifier.
2. The plug head has two buttons TEST/RESET. Press
the TEST button and the RESET button will pop out.
3. Press the RESET button and the TEST button
disengages.
4. The power supply cord is now supplying electricity to
the unit. Power is indicated by a green light on the
plug head.
DO NOT operate this unit with a damaged power cord.
If the power cord is damaged it must be replaced by the
manufacturer or a qualified/licensed service technician.
DO NOT use extension cords or plug adapters. These
actions may result in a fire hazard or electric shock.
This unit must be connected to a protective earthing
system prior to operation. DO NOT remove the
grounded connection while power is being supplied to
the Surna dehumidifier. Doing so presents an electric
shock hazard to users and service personnel.
This device is intended for indoor use only and should be
protected from rain and flooding.
This equipment is not meant for connection to a ducting
system.
Only use Surna supplied or recommended equipment
with the Surna dehumidifier.
Care must be taken when handling sheet metal. Sheet
metal parts have sharp edges and could cause serious
bodily injury.
The components of this unit have been inspected at the
factory and readied for shipment. Upon receiving the
shipment a visual inspection of the packaging must be
performed. Any shipping damage must be noted at time
of delivery.
DO NOT use this unit as a bench or table.
7
