SureShot ACFC-10, Operation Manual

Page: 7 / 24

ACFC-10 FlavorShot • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
3
UNPACKING AND SETUP
Unpacking the Dispenser
1. Position the box with the “This Side Up” arrow pointing upward.
2. Cut the packing straps from the box.
3. Lift the top from the box.
4. Remove the box sleeve by lifting it up and off the dispenser.
5. Lift the dispenser off the bottom of the box and place it on the counter.
Caution: Always lift the dispenser from the bottom.
Do not lift the dispenser by the door as this may damage the dispenser.
6. Remove the plastic protective covering from the stainless steel exterior of the
dispenser by peeling it off. To peel, hold the dispenser firmly at the top and peel from
top to bottom.
7. Remove the tape and plastic protective covering from the catch tray and screen.
8. Prior to use, read the Operations Manual. Store it for future use.
Inspect for Damage
Note: Damages incurred during shipment are not the responsibility of SureShot
Dispensing Systems® and are not covered by Warranty.
If you haven’t already done so, inspect packaging material for damage. Note any damage
in detail.
Unpack the dispenser immediately following the directions below. Examine the dispenser
for damage. Report any damage to the transportation company and file a claim for
damages within 24 hours. Your immediate inspection and reporting protects you against
loss.
Notify SureShot Dispensing Systems® within 24 hours of any damage claims. No returns
will be accepted without prior approval. Obtain an authorized return number by contacting
the SureShot Technical Assistance Center at 1-888-777-9990 or 902-865-9602.
Safety Precautions
•
Always plug the dispenser into an approved electrical outlet.
•
The dispenser includes a microcontroller and must be operated on grounded
electrical wiring at all times.
•
Unplug the dispenser from its electrical source before servicing.
•
Do not immerse the dispenser in water.
•
Observe all safety precautions with this dispenser that you would with any electrical
appliance.
Electrical Requirements
•
Power source receptacle: 120 V AC, 1 ph, 60 Hz. Uses a maximum of 1 amp.
•
The power cord is furnished with a UL-approved 3-prong attachment plug. This plug
is designed to fit a receptacle with provisions for a grounding stud. The dispenser
includes a microcontroller and must be operated on grounded electrical wiring at all
times. Failure to do so will void the Warranty.
•
The dispenser has an in-line power supply with both AC and DC power cords
attached. The DC power cord fits into a receptacle at the back of the dispenser.