SureShot ACFC-10, Operation Manual

Page: 16 / 24

ACFC-10 FlavorShot • SureShot Technical Assistance Center: 1-888-777-9990 or 902-865-9602
12
CLEANING AND MAINTENANCE
•
Clean the dispenser prior to first use.
•
Do not use any abrasive material or cleaners on the dispenser.
•
Dispenser must not be cleaned by water jet.
•
Do not spray any liquid or cleaners in or around the inside of the dispenser or
dispensing block. Liquid could damage electrical components of the dispenser.
Recommended Cleaning Schedule
Part or Area Procedure Frequency
Exterior See page 12
Button Panel See page 12
Catch Tray, Screen and Cup Guide See page 12
Product Dispense Block See page 13
Daily
Inside Dispenser Drawer See page 13 As required
Exterior
1. Wipe exterior surfaces using a soft cloth dampened with warm, clean, soapy water.
2. Rinse with warm, clean water. If the water is hard, wipe the dispenser dry with a soft
cloth to prevent water spotting.
3. A stainless steel cleaner is recommended. Spray cleaner on the cloth and then use
cloth to wipe exterior. Use on stainless steel surfaces only.
Note: Do not allow stainless steel cleaner to come in contact with the dispensing
block, button panel, door or any plastic parts.
Button Panel
1. Press and hold the
¦ /
▲
Panel Disable button until you hear a beep and lights on the
button panel flash in sequence.
2. Wipe the panel with a soft cloth dampened with warm, clean, soapy water.
3. Rinse with a soft cloth dampened with warm, clean water.
4. Button panel will automatically enable and return to normal operating mode after 30
seconds.
Catch Tray, Screen and Cup Guide
1. Remove the catch tray, screen and cup guide from the dispenser.
2. Rinse with warm, clean water.
3. Wash in hot water (minimum 140 °F/60 °C) with a good quality cleaner. Wash
thoroughly to reach all corners and crevices.
If a dishwasher is available, the items may be cleaned on the full wash cycle.
4. Rinse well with warm, clean water.
5. Air dry thoroughly.