SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
11
10
Installing Your Hardware
Installing Your Hardware
Step 3. Install the Indoor Antennas
Indoor antennas for the Fusion5X come with either two omni-directional domes or four directional panels.
• For indoor dome antennas, mount on a ceiling in a central location where signal is needed.
• For indoor panel antennas, mount on a wall or surface facing the area where signal is needed. These
directional antennas should always point away from the outdoor antenna. To avoid interference, retain a
minimum distance of 3 feet from panel antennas.
Option A: Install Indoor Dome Antennas
The SC-222W multi-band plastic antenna is an omni-directional interior antenna that gathers and sends
signals from all sides. Range of antenna is dependent on three factors:
1. Physical obstructions
2. Power generated by booster
3. Signal level received by the outdoor antenna
Besides the antenna itself, parts include mounting equipment for either a flat horizontal surface or a wall. It
should be mounted in an upright position for best results. You can also install your interior antenna above
the ceiling panel provided there are not materials that could obstruct signals.
For Each Indoor Dome Antenna:
1. Drill a 20 mm diameter hole in the ceiling. The ceiling thickness should be 20 mm, maximum.
2. Unscrew fixing nut from antenna. Place antenna cable through hole. Screw the fixing nut back onto
antenna and cable on crawl space side of ceiling and fasten.
3. Connect antenna to cable connector of one of the 75 ft. lengths of SC-400 cable and run along route to
planned location of your booster’s 4 way splitter.
4. Tighten fixing nut to secure antenna (do not over-tighten).
5. Once all indoor antennas and cables are in place, connect cable runs from indoor antennas to the
4-way splitter ports
6. Connect the provided 30 ft. of SC-400 cable to the remaining end of the splitter and route cable to the
planned location of your booster.
Note: Be sure to provide enough separation from outdoor antenna (at least 75 ft. is recommended).
Important:
•
Storage and transportation: Store and place in non-extreme room-temperature and dry environment
•
This antenna should not be used near open fire or flame.
Outdoor Omni
Outdoor
Cable
(75 ft.)
4-Way Splitter
Indoor Dome
Indoor Dome
Planned
booster
location
Indoor
Cables
(75 ft.)
Indoor
Cable
(30 ft.)
RF CABLE
THREADED MOUNT
CEILING
PLASTIC NUT
SC-400
Option B: Install Indoor Panel Antennas
The provided panel antennas are multi-band directional antennas with a 120˚
reach. They should be mounted facing the area signal is needed. It is also
important that they do not point toward the outdoor antenna. Range of antenna is
dependent on three factors:
1. Physical obstructions
2. Power generated by booster
3. Signal level received by the outdoor antenna
Besides the antenna itself, parts include mounting equipment for a flat horizontal
surface. You can also install your interior antenna behind a wall or above a ceiling
panel provided there are not materials that could obstruct signals.
OK
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
