SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
19
5.2 - Initial Configuration
By default, your booster ships with all DIP switches turned OFF to provide maximum gain in all
channels. This should always be your starting point whenever installing or reinstalling the booster.
5.3 - Powering on the Booster
To power on the booster:
1.
Make sure that exterior and interior antenna cables are firmly connected to the proper ports on
the booster.
2. Plug a surge suppressor into a grounded 110 VAC wall outlet.
3. Plug the AC end of the supplied power adapter into the surge suppressor.
4. Plug the DC end of the power adapter into the Power port on the booster.
5. Verify that the green
Power
light is illuminated.
5.4 – Testing
Once the booster is powered on and no Warning lights are illuminated, walk around the entire area to
test the voice and/or data signal. Refine the antenna locations and/or gain levels as needed, and then
complete the permanent installation once the system is working as desired.
5.5 - Adjusting the Booster
Keep the following points in mind when adjusting the booster:
• Full power is not always your best option. Your goal is to obtain a usable cellular signal in as
many areas of the building as possible. A successful installation means that you can make calls
without dropping and/or have a reliable data connection.
CAUTION: ONLY USE THE POWER SUPPLY INCLUDED
WITH THE BOOSTER. USE OF ANOTHER POWER
SUPPLY COULD DAMAGE THE BOOSTER AND/OR
POWER SUPPLY.
CAUTION: DO NOT PROCEED BEYOND THIS POINT
UNTIL THE BOOSTER IS POWERED ON AND NO RED
WARNING LIGHTS ARE ILLUMINATED.
Configuration and Testing
