SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
16
4.5 - Mounting the Booster
Mount the booster as follows:
1. Verify that the selected location meets all of the criteria described in the previous chapter.
2. Attach the included mounting kit to the booster using the screws provided. Tighten the screws
by hand with a screwdriver until tight plus 1/4 to 1/2 turn. Do not over-tighten.
3.
Mount 24 inch x 24 inch, 3⁄4 inch thick sheet of plywood on top of sheetrock into wall studs
where the booster is to be placed. Plywood should be flush against wall. Once mounted, screw
the booster to the plywood sheet. The top side of the booster with the lights and DIP switches
should be facing away from the wall and plainly visible standing near the booster.
4. Connect the exterior antenna cable to the
Outside Antenna
port on the booster.
5. Connect the interior antenna cable to the
Inside Antenna
port on the booster.
6. Verify that all cable connections are tight and that the exterior and interior antennas are
connected to the proper jacks.
Installation
