SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
15
CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS MEET
THE SEPARATION REQUIREMENTS DESCRIBED IN THE
PREVIOUS CHAPTER AND THAT NO ANTENNA IS AIMED
TOWARD THE EXTERIOR ANTENNA.
CAUTION: DO NOT CONNECT AN INTERIOR ANTENNA
TO THE SPLITTER INPUT.
4.4 - Internal Antennas
Mount the interior antenna(s) in the location(s) you selected during the planning process. Be sure to
follow the instructions included with the antenna(s) for a safe installation.
Remember: Dome antennas (SC-222W-TNC) should be mounted in the ceiling as close to the center
of the desired coverage area as possible with the domed side pointing down.
1. Mount the antenna.
2. Connect a length of SC-400-TNC cable to the antenna and tighten until hand-tight.
3. If you are installing multiple antennas, run the cable to the splitter location and connect the cable
to one of the outputs on the splitter.
4. Connect another length of SC-400-TNC cable to the input side of the splitter (if used) and run
this cable to the booster location.
5. It is important to keep the cable runs equal or use taps to ensure a harmonious install.
Installation
15.21 Information to user:
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that
changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. In cases where the manual is provided only in a form other than paper, such as
on a computer disk or over the Internet, the information required by this section may be included in the manual in
that alternative form, provided the user can reasonably be expected to have the capability to access information in
that form.
WARNING: Changes or modifications not expressly approved by SureCall will void the
user’s authority to operate the equipment.
