25/11/2014
7
3.1
Initial Startup
3.1.1
Unpacking and mounting
Open the packaging and carefully lift the machine off the pallet.
Make sure you do not damage the side and rear rubber flaps!
Lift the main panelling at the rear, and take the pins of the hood out
of their nests.
Remove the entire main panelling.
Unscrew the four star handles and remove the outer plastic wash-
ers.
To define the height adjustment of the driving hoop, you will have to
remove the frontal carriage bolts and set it to one of the three
height-levels.
In doing so observe the following:
Upper most position: driving hoop low.
Lowest position: driving hoop high (tall operators).
Push the driving hoop and the driving linkage through the opening
of the control panel.
1
Driving hoop
2
Driving linkage
3
Outer plastic washer
4
star handle
5
Front carriage bolt
6
Height-adjustment of the driving hoop
7
Driving linkage
8
Turnbuckle of the driving linkage
9
Borehole of the frontal
swivel lever
CAUTION!
Summary of Contents for ST1000E with TRS
Page 2: ...2 25 11 2014 ...
