12
11
In order to complete the setup of your connected system, you need to connect your Feeder to
your Household.
3
Your Hub will go into
connecting mode and its ears
will flash green.
1
Place your Feeder in its intended
location. This is to ensure it can
communicate with the Hub.
2
On the Sure Petcare app,
select ‘
Add product
’.
Press the settings button ' '
on the Feeder once. The ear
LED will illuminate green.
4
Once the Feeder is connected
the LED will turn off and the
Hub will stop flashing.
5
If you wish to connect more
Feeders, you can do this easily
from within the app.
5
Adding a Feeder to your current Household
You can add a Microchip Pet Feeder Connect to your existing Sure Petcare
Household via the app. Go to the Household section and follow the
instructions above.
You can also assign your pet's microchip ID remotely via the app. This means
you won't have to add them manually. However, adding pets using treats can
encourage them to use the new product.
See page 15
for more information
on adding pets.
Connect your Feeder
Batteries
Turn the Feeder upside down to
access the battery compartments.
Insert the batteries. Ensure the +/-
symbols on the batteries match the
symbols on the Feeder itself.
Remove the battery covers.
Replace the battery covers.
1
3
2
4
Always use
4 x good quality 1.5V alkaline C cell batteries.
This will ensure the best
performance of your Microchip Pet Feeder Connect.
This product is NOT designed for use
with rechargeable batteries.
To insert or change the batteries please follow the steps below:
+
-
There is a light near the rear of the Feeder. If the batteries are low, or if there’s a problem
with how they've been inserted, this light will flash red every 5 seconds.
+
-
Once you program your pet’s microchip ID into the Feeder it will be permanently
stored in its memory. This means that even when you change the batteries, the
Feeder will still recognise your authorised pet.
30cm
