17
SURE-FI, INC. |
www.sure-fi.com
Sure-Fi Serial Data Bridge
Supervised inputs (cont.)
At the Serial Data Central Interface, connect a jumper wire and two 1K Ohm resistors as shown in Figures 7
and 8 and wire to the Supervised inputs of the Control panel, then set the inputs as NO or NC type in the
Control panel software. The four-state resistance values shown in Figures 5 and 6 will be presented to the
Access Control Panel inputs just as if connected directly to the Supervised input device.
Figure 7: Relay 1 Supervised Input wiring connections at the Access Control Panel.
Figure 8: Relay 2 Supervised Input wiring connections at the Access Control Panel.
