16
PC5010 Control Panels
NOTE
:
:
:
:
: The DSC PC5010 panel must be equipped with software version 1.0 or later.
The maximum permissible entry delay time programmed on the panel should be 30 seconds.
Programming the PC5010 for LINKS1000 Operation
Section [009]
LINKS Enable:
Program [16] into section 009. This will reserve the PGM1 output for LINKS1000
communications. Only PGM1 will support LINKS1000 operation.
Section [001]
LINKS Supervisory:
- [004]
Choose the zone that will be used to report the 24 hour LINKS1000 supervisory alarms
[section 001 to 004]. Program that zone as [09].
Downloading via LINKS1000:
If Downloading via cellular is to be used, choose a zone to perform LINKS Answer. Program
the chosen zone as [24]. This will force the panel to answer an incoming cellular call.
Section [320]
LINKS Trouble Reporting Code:
- [323]
In section 320 to 323, enter the desired reporting code for LINKS1000 Trouble reporting. Use
same zone as LINKS supervisory.
Section [349]
TLM Trouble Reporting via LINKS:
Go to section 349. Find TLM Trouble Code (via LINKS). Enter the desired reporting code. The
Restoral is contained in section 350, this will not be sent via the LINKS.
Section [352]
LINKS Test Transmission:
Program the LINKS Test Transmission code in section 352. The LINKS will follow the land line
test transmission schedule.
Section [361]
LINKS Call Direction Options:
- [368]
Go to sections 361 to 368. Determine which signal types will be sent via LINKS1000. Section
380, zone light [7] dictates whether the LINKS will be used as backup or primary
communications. When set to primary, the LINKS will always place a cellular call on signals
so identified in Call Directions.
Section [390]
LINKS Preamble:
- [392]
Program sections 390 to 392 with preambles (if necessary) for each communicator
outbound telephone number.
Section [490]
LINKS Downloading Preamble:
If necessary, program section 490 with the LINKS Preamble for the Downloading.
Section [703]
Dialling Delay:
Program section 703 with 010. This places a necessary delay between LINKS (and all other)
dial attempts.
Power-up Procedure
Apply power to the transformer and wait approximately 10 seconds. If LED1 begins to flicker once every 4 to
5 seconds, check the following:
• Ensure that the PGMIn and GND terminals are properly wired
• Ensure that the Control Panel is programmed for LINKS operation
NOTE : The LINKS1000 will not operate if the AC is off and the battery is low. The LINKS1000 should not
be powered up without the antenna attached to the unit.
