8
2.2 -
POSITIONING
Position the pallet, with the slicer, on a
flat surface and take off (
a
) the
sharpener from the slicer (
Fig. n°12
).
At this point turn the machine on its
side (
Fig. n°13
) and unscrew, with the
proper wrench provided, the 4 nuts
which fasten the slicer. Remove the 4
washers and unscrew the 4 fastening
tie rods on the wooden pallet. Take off
the pallet and fasten the 4 feet
provided. Finally, put the sharpener in
its place.
Position the slicer in the predestined
place.
The dimensions indicated in
Tab. 1-2-3
(according to the model) must be kept
in mind for the plane where the slicer
will be installed, therefore it must be
wide
enough,
well-levelled,
dry,
smooth, robust, stable about 80 cm
high off the ground and at least 20 cm
from walls, objects, shelves, etc. (
Fig.
n°14
)
in
respect
to
the
space
necessary for its use and safeguarding.
Furthermore the machine must be
placed in an environment with a
maximum humidity of 75%, not salty
and with a temperature between +5°C
and
+35°C;
in
any
case
in
environments which do not lead to
deviations of the above.
Make sure the graduated handgrip is in
posiion “0”.
Check the alignment of the blade-plane
thickness gauge by running a finger
(
Fig. n°16
) from the blade towards the
thickness gauge plane (never in the
opposite direction). Unscrew and screw
the foot (1) until the correct alignment is
found (
Fig. n°17
), then screw the
rubber part (2) to fix everything (
Fig. n°
17
).
a
~ 80cm
20cm
Fig. n°12
Fig. n°13
Fig. n°14
Fig. n°15
Fig. n°16
Fig. n°17
20cm
20cm
20cm
1
2
21
therefore the cutting effort increases (
chapter 5.3
).
5.3 -
SHARPENING THE BLADE
1. disinsert the plug from the outlet and
carefully
clean
the
blade
with
denatured alcohol so it is degreased;
2. lift (a) the sharpener (1) and turn it
180° (b
Fig. n°43
);
WARNING: Before starting to sharpen the blade, pay attention to
RESIDUAL RISKS (chapter 4.2.2) concerning the dangers of cutting without
having followed the instructions listed below.
To sharpen the blade, which needs to be done periodically as soon a decrease
in cutting is noticed, the following directions must be adhered to:
Fig. n°42
Fig. n°43
c
d
3. let it go in a way that the sharpener
(c) fits on the locator pins (d
Fig. n°
43
);
4. check also that the blade stays
between the two grinders;
1
b
a
5. insert the pin and start the machine,
by pressing the “ON” push-button;
6. press the push-button (2
Fig.n°44
),
let the blade rotate in contact with the
grinder for about 30/40 sec. so that a
slight burr forms on the blade edge;
7. press the 2 push-buttons (2 and 3)
contemporaneously for 3/4 sec. and
release them in the same instant
(
Fig. n°45
);
8. after
having
completed
the
sharpening it is advisable to clean the
Fig. n°44
2
Summary of Contents for SSG300PTB
Page 2: ...2 27 ...
