ELECTRONIC CONTROL PANEL
SETTING THE TIME AND DAY OF THE WEEK
Setting the time should take place only in case when the
appliance is connected to the power supply (the first start-
up) and in case when the reset occurred during longer
power outage. In such case, after restarting the controller
the figures indicating the time are flashing.
Step 1: Press the button „SET CLOCK”.
SET CLOCK
+
-
REGEN
NEXT
TIME OF DAY
LPM 0
12:00
WED
Step 2: SETTING THE TIME (HOUR): Set proper figure of
„hour” by pressing the buttons „+” or „-”.
Pressing the button „NEXT” causes going to the next
parameter. You can go back to the previous step anytime
by pressing the button „REGEN”.
SET CLOCK
+
-
REGEN
NEXT
TIME
HOUR
SET
16:00
Step 3: SETTING THE TIME (MINUTES): Set proper figure of
„minutes” by pressing the buttons „+” or „-”. Pressing the
button „NEXT” causes going to the next parameter. You
can go back to the previous step anytime by pressing the
button „REGEN”.
SET CLOCK
+
-
REGEN
NEXT
TIME
MINUTES
SET
16:23
Step 4: SETTING THE PROPER DAY OF THE WEEK: Set the
day of the week by pressing the buttons „+” or „-”. Pressing
the button „NEXT” causes going to the next parameter.
You can go back to the previous step anytime by pressing
the button „REGEN”.
RETURN
TO THE MAIN
DISPLAY
SET CLOCK
+
-
REGEN
NEXT
CURRENT DAY
SET
WED
The properly programmed controller should display the
information:
Current water consumption expressed in l/min.
Current time
Current day of week
SET CLOCK
+
-
REGEN
NEXT
TIME OF DAY
LPM 0
16:23
WED
APPLIANCE PROGRAMMING
Step 1: Press the buttons „NEXT and „+” at the same time.
SET CLOCK
+
-
REGEN
NEXT
9
