Supore ALE-1200, Operation Manual, Page: 27 / 41

- 26 -
I
MPORTANT NOTE ：
> Automatic bevel
The tip vertex position is automatically located 1/3 of the front of the lens.
>33% bevel
The apex of the tip is located about 33 percent above the front of the lens.
> 50% bevel
The apex of the tip is located at 50% of the front surface of the lens.
> Front bevel
The tip vertex position is located on the front surface.
> Back bevel
The apex of the tip is located on the back surface.
I
MPORTANT NOTE
：
> If the maximum thickness of the lens is less than 2mm, the position of the bevel/slot will be
automatically located at half of the lens.
#7 Select lens processing mode
；
#9 After blocking, put the lens in and clamp
；
#10 Start
；
#11 Open the window, remove the shaft and take
the lens after it’s done.
#8 Select clip pressure
；