Chapter 1: Introduction
1-13
Introduction
Wake-On-LAN (WOL)
Wake-On-LAN is defined as the ability of a management application to re-
motely power up a computer that is powered off. Remote PC setup, up-
dates and asset tracking can occur after hours and on weekends so that
daily LAN traffic is kept to a minimum and users are not interrupted. The
motherboard has a 3-pin header (WOL) to connect to the 3-pin header on a
Network Interface Card (NIC) that has WOL capability. Wake-On-LAN must
be enabled in BIOS. Note that Wake-On-LAN can only be used with an ATX
2.01 (or above) compliant power supply.
1-6
Power Supply
As with all computer products, a stable power source is necessary for
proper and reliable operation. It is even more important for processors that
have high CPU clock rates.
The SUPER X6DH8-G/X6DHE-G accommodates ATX 24-pin power supplies.
Although most power supplies generally meet the specifications required by
the CPU, some are inadequate. You should use one that will supply at least
400W of power. Your power supply must supply 1.5A for the Ethernet
ports. The +12V, 4-pin power connector (J38) is required to ensure ad-
equate power supply to the system. Additionally, you should also use the
onboard 12V 8-pin power connector (J1D1) to support Intel Xeon CPUs.
Failure to provide this extra power will result in instability of the CPU after
only a few minutes of operation. See Section 2-5 for details on connecting
the power supply.
It is strongly recommended that you use a high quality power supply that
meets ATX power supply Specification 2.02 or above. It must also be SSI
compliant (info at http://www.ssiforum.org/). Additionally, in areas where
noisy power transmission is present, you may choose to install a line filter
to shield the computer from noise. It is recommended that you also install a
power surge protector to help avoid problems caused by power surges.