Supero SuperWorkstation 5037A-i2-MA015, User Manual

Page: 23 / 50

Chapter 3: Component Installation
3-3
Installing an LGA 2011 Processor
1. There are two levers on the
LGA2011 socket. First press and
release the load lever labeled
'Open 1st'.
2. Press the second load lever
labeled 'Close 1st' to release the
load plate from its locked position.
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
OPEN 1st OPEN
1st
WARNING! WAR
NIN
G!
Press down on the lever labeled
'Close 1st'
Pull lever away
from the socket
3-4 Installing a CPU and Heat Sink
Caution: When handling the processor package, avoid placing direct pressure on
the label area of the fan.
Preparation
1. Begin by removing power from the system as described on page 3-1. Always
connect the power cord last and always remove it before adding, removing or
changing the CPU. Install the processor into the CPU socket before installing
the CPU heat sink.
2. If buying a CPU separately, use an Intel-certifi ed multi-directional heat sink
only.
3. If installing a new motherboard, make sure to install the motherboard into the
chassis before installing the CPU heat sinks.
4. When a motherboard has no CPU pre-installed, make sure that the plastic
CPU socket cap is in place and none of the socket pins are bent; otherwise,
contact your retailer immediately.
5. Refer to the Supermicro Web site for updates on CPU support.