Supero SUPERSERVER 6037R-TXRF, User Manual

Page: 62 / 104

6-6
S
UPER
S
ERVER 6037R-TXRF User's Manual
Air Shroud
Air shrouds concentrate airflow to maximize fan efficiency. The SC835 chassis air
shroud does not require screws to set up.
Installing the Air Shroud
1. Remove the chassis cover. If necessary, remove the rear fans
2. Place the air shroud in the chassis (see Figure 6-4). The shroud aligns with
the fan holders and covers two of the front fans with the rear exhaust fan.
Make sure the air shroud aligns completely with the chassis
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
SATA Drives: You do not need to access the inside of the chassis or remove power
to replace or swap SATA drives. Proceed to the next step for instructions.
You must
use standard 3.5" SATA drives in the system.
DVD-ROM: A DVD drive is included as an option only with the 6037R-TXRF. For
installing/removing the DVD-ROM drive, you will need to gain access to the inside
of the server by removing the top cover of the chassis. Proceed to the "DVD-ROM
Installation" section later in this chapter for instructions.
Hard Drive Backplane
The hard drives plug into a backplane that provides power, drive ID and bus termi-
nation. A RAID controller can be used with the backplane to provide data security.
The operating system you use must have RAID support to enable the hot-swap
capability of the hard drives. The backplane is already preconfigured, so no jumper
or switch configurations are required.
SATA Drive Installation
These drives are mounted in drive carriers to simplify their installation and removal
from the chassis. The carriers also help promote proper airflow for the drives. For this
reason, even empty carriers without hard drives installed must remain in the chassis.