Supero SuperServer 6026T-URF, User Manual

Page: 44 / 98

5-12
S
UPER
S
ERVER 6026T-URF User's Manual
5-8 Connector Defi nitions
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
ATX Power Connector
The primary ATX power supply con-
nector meets the SSI EPS 12V speci-
fi cation. Make sure that the orientation
of the connector is correct. See the
table on the right for pin defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
NMI Button
Pin Defi nitions (JF1)
Pin# Defi nition
19 Control
20 Ground
Processor Power
Pin Defi nitions (JPW2/JPW3)
Pins Defi nition
1 through 4 Ground
5 through 8 +12V
Power LED
Pin Defi nitions (JF1)
Pin# Defi nition
15 Vcc
16 Control
Processor Power Connectors
JPW2 and JPW3 must also be con-
nected to the power supply to provide
power for the processor(s). See the
table on the right for pin defi nitions.
Warning : To prevent damage to your power supply or serverboard, please
use a power supply that contains a 20-pin and two 8-pin power connec-
tors. Be sure to connect these power connectors to the 20-pin and the two
8-pin power connectors on your serverboard for adequate power supply to
your system. Failure to do so will void the manufacturer warranty on your
power supply and serverboard.
ATX Power 20-pin Connector
Pin Defi nitions (JPW1)
Pin# Defi nition Pin # Defi nition
11 PS On 1 Ground
12 5VSB 2 Ground
13 Ground 3 Ground
14 Ground 4 Ground
15 Ground 5 Ground
16 NC2 6 NC1
17 12V 7 12V
18 12V 8 12V
19 12V 9 12V
20 12V 10 12V
!