Supero SUPERSERVER 6017R-NTF, User Manual

Page: 91 / 126

Chapter 6: Advanced Chassis Setup
6-7
Removing the Chassis Cover
1. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
2. Depress the two buttons on the top of the chassis to release the top cover
and at the same time, push the cover away from you until it stops. You can
then lift the top cover from the chassis to gain full access to the inside of the
server.
Removing/Installing a Drive
1. With the chassis cover removed, unplug the power and data cables from the
drive you want to remove.
2. Locate the locking tab at the rear of the drive. It will be on the left side of the
drive when viewed from the front of the chassis.
3. Pull the tab away from the drive and push the drive unit out the front of the
chassis.
4. Add a new drive by following this procedure in reverse order. You may hear a
faint *click* of the locking tab when the drive is fully inserted.
5. Remember to reconnect the data and power cables to the drive before
replacing the chassis cover and restoring power to the system.
6-5 Power Supply
The SuperServer 6017R-WRF/NTF has either a redundant 700 Watt (Model # PWS-
704P-1R) consisting of two hot-swap power modules or a single 600 Watt (Model
# PWS-605P-1H) power supply confi guration. The power supply modules have an
auto-switching capability, which enables them to automatically sense and operate
with a 100V - 240V input voltage.
Redundant Power Supply Failure
If either of the two redundant power supply modules fail, the other module will
take the full load and allow the system to continue operation without interruption.
The Universal Information LED on the control panel will blink slowly and remain so
until the failed module has been replaced. Replacement modules can be ordered
directly from Supermicro (see contact information in the Preface). The power supply
modules have a hot-swap capability, meaning you can replace the failed module
without powering down the system.