Supero SUPERSERVER 6015C-M3, User Manual

Page: 42 / 118

5-8
S
UPER
S
ERVER 6015C-M3/6015C-MT User's Manual
5-6 Installing Memory
Memory Support
The X7DCL-3/X7DCL-i supports up to 48 GB of Registered ECC DDR2-667 or
DDR2-533 SDRAM. The memory scheme is interleaved, so you must populate two
slots at a time, beginning with slot 1A and 2A, then slots 1B and 2B and fi nally slots
1C and 2C. You may populate any even number (2, 4 or 6) of DIMMs. See chart
below for optimizing your DIMM installation.
Installing Memory Modules
Insert the desired number of DIMMs into the memory slots, starting with 1.
DIMM #1A. The memory scheme is interleaved, so you must install two
modules at a time, beginning with slots 1A and 2A, then slots 1B and 2B,
then slots 1C and slot 2C. See the Memory Installation table Below.
Pay attention to the notches along the bottom of the module to prevent insert- 2.
ing it incorrectly.
Gently 3. press down on the DIMM module until it snaps into place in the slot
(see Figure 5-3).
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom
notches.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
Figure 5-3. DIMM Installation
Note: Notch
should align
with its
receptive point
on the slot
Notch
Notch
Release
Tab
Release
Tab
Memory Installation Table
No. of
DIMMs
Channel 0 Channel 1
2DIMMs 1A ------ ------ 2A ------ ------
4DIMMs 1A 1B ------ 2A 2B ------
6DIMMs 1A 1B 1C 2A 2B 2C
Notes: 1. DIMM slot# specified = DIMM slot to be populated. “---“ = DIMM slot to be left
unpopulated. 2. Both DDR2 533 MHz and 667MHz DIMMs are supported; however, you
need to use the memory modules of the same speed and type.