Supero SUPERSERVER 5018A-TN4, User Manual

Page: 53 / 114

Chapter 5: Advanced Motherboard Setup
5-11
Power LED/Speaker
On the JD1 header, pins 1~3 are used for
a power LED and pins 4~7 are used for
an external speaker. If you wish to use
the onboard speaker, you should close
pins 6-7 with a jumper. See the table on
the right for speaker pin definitions.
Speaker Connector
Pin Definitions
Pin Setting Definition
Pins 6-7 Internal Speaker
Pins 4-7 External Speaker
Internal Speaker/Buzzer
The Internal Speaker on SP1 can be
used to provide audible indications for
various beep codes. See the table on
the right for pin definitions.
Internal Buzzer
Pin Definition
Pin# Definitions
Pin 1 Pos. (+) Beep In
Pin 2 Neg. (-) Alarm
Speaker
TPM Header
The TPM header is used to connect a
Trusted Platform Module (TPM), avail-
able from a third-party vendor. A TPM is
a security device that allows encryption
and authentication of hard drives. It en-
ables the motherboard to deny access if
the TPM associated with the hard drive is
not installed in the system. See the table
on the right for pin definitions.
Trusted Platform Module Header
Pin Definitions
Pin # Definition Pin # Definition
1 LCLK 2 GND
3 LFRAME 4 No Pin
5 LRESET 6 VCC5
7 LAD3 8 LAD2
9 VCC3 10 LAD1
11 LAD0 12 GND
13 RSV0 14 RSV1
15 SB3V 16 SERIRQ
17 GND 18 CLKRUN
19 LPCPD 20 RSV2
PWR LED Connector
Pin Definitions
Pin# Definition
1 Anode (+)
2 Cathode (-)
3 NA
LAN3/LAN4 LED Indication Header
Connect an appropriate cable to the
LAN 3/4 LED header located at JPK1 to
indicate activity status of LAN Port 3 or
LAN Port 4. LAN1/LAN2 LED indicator
connections are located on pins 9/10,
11/12 of the front control panel (JF1)
header.