Supero SuperServer 5017R-MF, User Manual

Page: 52 / 106

5-20
S
UPER
S
ERVER 5017R-MF User's Manual
DOM PWR Connector
The Disk-On-Module (DOM) power con-
nector, located at JSD1, provides 5V
(Gen1/Gen) power to a solid state DOM
storage device connected to one of the
SATA ports. See the table on the right for
pin defi nitions.
DOM PWR Connector
Pin Defi nitions
Pin Defi nition
1 5V
2 Ground
3 Ground
Serial_Link-SGPIO
Pin Defi nitions
Pin# Defi nition Pin Defi nition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
T-SGPIO 1/2 & 3-SGPIO 1/2 Headers
Two T-SGPIO (Serial-Link General Pur-
pose Input/Output) headers are located
next to the I-SATA ports on the mother-
board. Additionally, two 3-SGPIO ports
are also located next to JUSB 8/9. These
headers are used to communicate with
the enclosure management chip in the
system. See the table on the right for pin
defi nitions.
Internal Buzzer (SP1)
The Internal Buzzer (SP1) can be used
to provide audible indications for various
beep codes. See the table on the right for
pin defi nitions.
Internal Buzzer
Pin Defi nition
Pin# Defi nitions
Pin 1 Pos. (+) Beep In
Pin 2 Neg. (-) Alarm
Speaker
Unit ID Switch (UID SW)
The rear UID switch, the rear UID LED
and front UID LED on JF1 are designed
to work together. When the user pushes
the rear UID switch, the blue backpanel
UID LED and front UID LED will turn on.
Push the rear UID switch again to turn
off UID LED and the front UID LED. This
provides easy identifi cation of a system
unit that may be in need of service.
UID Switch
Pin# Defi nition
1 Button In
2 Ground
3 Ground
4 Ground