Supero SUPERSERVER 5016I-M6F, User Manual

Page: 51 / 102

Chapter 5: Advanced Motherboard Setup
5-17
Fan Headers
The X8SI6-F has fi ve fan headers, all
of which are 4-pin fans. However, pins
1-3 of the fan headers are backward
compatible with the traditional 3-pin
fans. See the table on the right for
pin definitions. Fan 1 is intended
for use with the CPU. A fan speed
control setting in the BIOS Hardware
Monitoring section allows the BIOS to
automatically set fan speeds based on
the system temperature. The default
setting is Disabled which allows the
onboard fans to run at full speed.
Refer to the table on the right for pin
defi nitions.
ATX PS/2 Keyboard and PS/2
Mouse Ports
The ATX PS/2 keyboard and the PS/2
mouse are located on the I/O back-
panel. The mouse port is above the
keyboard port. See the table on the
right for pin defi nitions.
Fan Header
Pin Defi nitions
Pin# Defi nition
1 Ground (Black)
2 2.5A/+16V (Red)
3 Tachometer
4 PWM Control
PS/2 Keyboard and
Mouse Port Pin
Defi nitions
Pin# Defi nition
1 Data
2 NC
3 Ground
4 VCC
5 Clock
6 NC
Chassis Intrusion
The Chassis Intrusion header is des-
ignated JL1. Attach an appropriate
cable from the chassis to inform you
of a chassis intrusion when the chas-
sis is opened
Chassis Intrusion
Pin Defi nitions
Pin# Defi nition
1 Intrusion Input
2 Ground
Note : Please use all 3-pin fans or all 4-pin fans
on a motherboard. Please do not use 3-pin fans
and 4-pin fans on the same board.
Speaker
On the JD1 header, pins 3~4 are used
for internal speaker. Close pins 3~4
with a cap to use the onboard speaker.
If you wish to use an external speaker,
close pins 1~4 with a cable. See the
table on the right for pin defi nitions.
Speaker Connector
Pin Defi nitions
Pin Setting Defi nition
Pins 3~4 Internal Speaker
Pins1~4 External Speaker