Supero SUPERSERVER 5010E, User Manual

Page: 64 / 128

6-2
S
UPER
S
ERVER
5010H/5010E
Manual
UPER
S
R
S
UPER
R
Figure 6-2. Chassis Rear View
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the motherboard to provide you with system
status indications. A ribbon cable has bundled these wires together to
simplify the connection. Connect the cable from JF1 on the motherboard
to JP4 on the Control Panel PCB (printed circuit board). Make sure the
red wire plugs into pin 1 on both JF1 and JP4. Pull all excess cabling out
of the airflow path. The LEDs inform you of system status. See Chapter
3: System Interface for details on the LEDs and the control panel buttons.
Details on JF1 can be found in the Chapter 5: Advanced Motherboard
Installation.
Main Power
Slim CD-ROM Drive
Floppy Drive
Screws (3 on each side)
SCSI Drives
PCI Card
Release Latch
System Reset
Control Panel/
System LEDs
IDE Drives
5010E
5010H
Rack Unit Retention
Figure 6-1. Chassis Front Views
5010E
5010H
External SCSI Connector
PCI Slot