Supero SUPERSERVER 2027TR-H72FRF, User Manual

Page: 75 / 134

Chapter 5: Advanced Motherboard Setup
5-21
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that can reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an application
hangs. Close Pins 2-3 to generate
non-maskable interrupt signals for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
VGA Enable (JPG1)
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled (Default)
2-3 Disabled
BMC Enable
Jumper JPB1 allows you to enable the
onboard BMC (Baseboard Management)
Controller to provide IPMI 2.O/KVM
support on the motherboard. See the
table on the right for jumper settings.
BMC Enable (JPB1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 BMC Enable (Default)
Pins 2-3 Normal
Infi niBand (IB) Enable
Both the X9DRT-HIBQF and X9DRT-
HIBFF serverboards have Jumper JIB1,
which allows you to enable the onboard
Infi niBand connector. The default setting
is 1-2 to enable the connection. See the
table on the right for jumper settings.
Infi niBand Enable (JIB1)
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled (Default)
2-3 Disabled