Supero SuperServer 1027GR-72R2+, User Manual

Page: 83 / 124

Chapter 6: Advanced Chassis Setup
6-7
Warning: Except for short periods of time (e.g. when swapping hard drives), do not
operate the server with the hard drive carriers removed.
3. Align the drive in the carrier so that the screw holes of both line up. Note that
there are holes in the carrier marked “SATA” to aid in correct installation.
4. Secure the drive to the carrier with four M3 screws as illustrated below. These
screws are included in the chassis accessory box.
5. Insert the drive carrier into its bay, keeping the carrier oriented so that the
hard drive is on the top of the carrier and the release button is on the right
side. When the carrier reaches the rear of the bay, the release handle will
retract.
6. Push the handle in until it clicks into its locked position
Figure 6-6. Removing a Hard Drive Carrier
1
1
1
2