Supero SuperServer 1026GT-TF, User Manual

Page: 83 / 104

Chapter 7: BIOS
7-15
X
Super IO Device Confi guration
Serial Port1 Address/Serial Port2 Address (-Serial Port2 is used for BMC
Serial Over LAN support. It does not have physical Serial Port2 on the MB.)
This option specifi es the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial port
physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8
as its I/O port address and IRQ 4 for the interrupt address. The options for Serial
Port1 are Disabled, 3F8/IRQ4 , 3E8/IRQ4, 2E8/IRQ3. The options for Serial Port2
are Disabled, 2F8/IRQ3 , 3E8/IRQ4, and 2E8/IRQ3.
X
Remote Access Confi guration
Remote Access
This allows the user to enable Remote Access support. The options are Disabled
and Enabled . If Remote Access is set to Enabled, the following items will display:
Serial Port Number
This feature allows the user decide which serial port to be used for Console
Redirection. The options are COM 1 and COM2,
Base Address, IRQ
This item displays the base address and IRQ of the serial port used for
Console Redirection.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are 115200 8, n 1 ; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and
9600 8, n, 1.
Flow Control
This feature allows the user to set the fl ow control for Console Redirection. The
options are None , Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after Power-On Self-Test
(POST). Select Always to keep Console Redirection active all the time after
POST. (Note: This setting may not be supported by some operating systems.)
Select Boot Loader to keep Console Redirection active during POST and Boot
Loader. The options are Disabled, Boot Loader, and Always .