Supero Supero SuperServer 5037C-T, User Manual

Page: 44 / 90

5-20
S
UPER
S
ERVER 5037C-T User's Manual
DOM PWR Connector
The Disk-On-Module (DOM) power con-
nector, located at JWF1, provides 5V
(Gen1/Gen) power to a solid_state DOM
storage device connected to one of the
SATA ports. See the table on the right for
pin defi nitions.
DOM PWR Connector
Pin Defi nitions
Pin Defi nition
1 5V
2 Ground
3 Ground
Serial_Link-SGPIO
Pin Defi nitions
Pin# Defi nition Pin Defi nition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
T-SGPIO 0/1 Headers
Two T-SGPIO (Serial-Link General Pur-
pose Input/Output) headers are located
near the SATA connectors on the moth-
erboard. These headers are used to com-
municate with the enclosure management
chip in the system. See the table on
the right for pin defi nitions. Refer to the
board layout below for the locations of
the headers.
Wake-On-LAN (JWOL)
The Wake-On-LAN header is located
at JWOL on the motherboard. See the
table on the right for pin definitions.
(You must also have a LAN card with a
Wake-On-LAN connector and cable to
use this feature.)
Wake-On-LAN
Pin Defi nitions
(JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
Unit ID Switch
The rear UID switch, the rear UID LED
and front UID LED on JF1 are designed
to work together. When the user pushes
the rear UID switch, the blue backpanel
UID LED (LE5) and front UID LED will
turn on. Push the rear UID switch again
to turn off both LEDs. This provides easy
identifi cation of a system unit that may be
in need of service.
UID Switch
Pin# Defi nition
1 Ground
2 Ground
3 Button In
4 Ground