Supero Supero H8DCE, User Manual

Page: 20 / 78

2-2
H8DCE User's Manual
!
2-2 Processor and Heatsink Installation
Installing the Processor (install to the CPU#1 socket fi rst)
1. Lift the lever on CPU socket #1 until
it points straight up.
2. Use your thumb and your index fi n-
ger to hold the CPU. Locate pin 1 on
the CPU socket and pin 1 on the CPU.
Both are marked with a triangle.
3. Align pin 1 of the CPU with pin 1
of the socket. Once aligned, carefully
place the CPU into the socket. Do not
drop the CPU on the socket, move the
CPU horizontally or vertically or rub the
CPU against the socket or against any
pins of the socket, which may damage
the CPU and/or the socket .
Triangles
Installing the CPU Backplates
Two CPU backplates (BKT-0004) are included in the retail box. The backplates
prevent the CPU area of the serverboard from bending and provide a base for at-
taching the heatsink retention modules. To install, begin by peeling off the release
paper to expose the adhesive. On the underside of the serverboard, locate the two
holes on either side of the CPU socket. Attach the adhesive side of the backplate
to the board by inserting the standoffs into the two holes and applying light pressure
so that the backplate sticks to the underside of the board. Repeat for the second
CPU socket. See Figure 2-1.
Exercise extreme caution when handling and installing the processor.
Always connect the power cord last and always remove it before
adding, removing or changing any hardware components.