Supero SUPER P6DGE, User'S And Bios Manual

Page: 75 / 98

Chapter 5: Running Setup
5-15
Slow Clock Ratio
The value of the slow clock ratio indicates the percentage of time the
STPCLK# signal is asserted while in the thermal throttle mode. The
settings are Disabled, 0-12.5%, 12.5-25%, 25-37.5%, 37.5-50%, 50-
62.5%, 62.5-75%, or 75-87.5%.
Display Activity
This option specifies if AMIBIOS is to monitor display activity for power
conservation purposes. When this option is set to Monitor and there is
no display activity for the length of time specified in the Standby Timeout
(Minute) option, the computer enters a power savings state. The settings
are Monitor or Ignore.
Device 6 (Serial port 1)
Device 7 (Serial port 2)
Device 8 (Parallel port)
Device 5 (Floppy disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Slave IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE)
When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the
computer is in a power saving state, AMIBIOS watches for activity on the
specifies IRQ line. The computer enters the Full On state if any activity
occurs. AMIBIOS reloads the Standby and Suspend timeout timers if
activity occurs on the specified IRQ line. Note: The Optimal default
setting for each option is Ignore with the exception of Devices 0
(Primary Master IDE) and 6 (Serial Port 1) which should be set to
Monitor. The Fail-Safe default for each option is Monitor.
LAN Wake-Up
RTC Wake-UP
Options for LAN Wake-Up and RTC Wake-Up are Disabled or Enabled.
When enabled, the Hour and Minute functions become available.
5-1-5 PCI/PnP Setup
Plug and Play-Aware OS
The settings for this option are No or Yes. Set this option to Yes if the
operating system in the computer is aware of and follows the Plug and
Play specification. AMIBIOS only detects and enables PnP ISA adapter