Supero SUPER P6DGE, User'S And Bios Manual

Page: 63 / 98

Chapter 5: Running Setup
5-3
Date and Time Configuration
Select the Standard option. Select the Date/Time icon. The current
values for each category are displayed. Enter new values through the
keyboard.
Floppy A
Floppy B
Choose the Floppy Drive A or B icon to specify the floppy drive type.
The settings are Not Installed, 360 KB 5¼ inch, 1.2 MB 5¼ inch, 720 KB
3½ inch, 1.44 MB 3½ inch or 2.88 MB 3½ inch. Note: The Optimal
and Fail-Safe settings for Floppy Drive A are 1.44 MB 3 1/2 inch
and for Floppy Drive B are Not Installed.
5-1-2 Advanced Setup
Quick Boot
The Settings are Disabled or Enabled. Set to Enabled to permit
AMIBIOS to boot quickly when the computer is powered on. This option
replaces the old Above 1 MB Memory Test Advanced Setup option.
The
settings are:
Setting Description
Disabled AMIBIOS tests all system memory. AMIBIOS waits
up to 40 seconds for a READY signal from the IDE
hard disk drive. AMIBIOS waits for .5 seconds after
sending a RESET signal to the IDE drive to allow the
IDE drive time to get ready again. AMIBIOS checks
for a <Del> key press and runs AMIBIOS Setup if the
key has been pressed.
Enabled AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY
signal from the IDE hard disk drive. If a READY signal
is not received immediately from the IDE drive, AMIBIOS
does not configure that drive. AMIBIOS does not wait
for .5 seconds after sending a RESET signal to the IDE
drive to allow the IDE drive time to get ready again. In
Enabled, keyboard will be bypassed.
Note: You cannot run AMIBIOS Setup at system boot, because
there is no delay for the Hit <Del> to run Setup message
.