Supero SUPER P4DE8, User Manual

Page: 29 / 86

Chapter 2: Installation
2-5
To Remove:
Use your thumbs to
gently push near the
edge of both ends of
the module. This
should release it from
the slot.
Figure 2-2. Installing and Removing DIMMs
To Install:
Insert the module vertically
and press down until it
snaps into place. Pay
attention to the notch on
the bottom of the module.
2-3 Installing DIMMs
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
DIMM Installation (See Figure 2-2)
1. Insert one to four memory modules. Memory is not interleaved, so you
can add any number of DIMMs into the slots in any order.
2. Insert each DIMM module into its slot. Note the notch at the bottom of the
module to prevent inserting the module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for more modules as desired.
Support
The P4DE8/P4DEI/P4DEE supports up to 4 GB of ECC registered DDR-200
(PC1600) SDRAM memory.