5-13
Chapter 5: Chassis Setup and Maintenance
Blower Setup
SC512 chassis models SC512, SC512C and SC512L are blower-cooled. In the
unlikely event that the blower fails, replacement is simple and can be accomplished
with a Phillips head screwdriver.
Replacing the Blower
Disconnect the chassis from any power source.
1.
Remove the two long screws at the front of the blower and the two long
2.
screws at the back of the blower and set them aside for later use.
Lift the blower up and out of the chassis and disconnect the wiring.
3.
Replace the blower with another blower of the same model and reconnect the
4.
wiring.
Align the thru holes in the blower with the thru holes in the chassis.
5.
Secure the blower to the chassis using the screws previously set aside.
6.
Close the cover and reconnect power to the chassis.
7.
Figure 5-12: Installing the Blower
Long Screws
