Supero P4DCE Plus II, User Manual

Page: 28 / 95

2-2
S
UPER P4DC6/P4DC6+/P4DC6+II/P4DCE/P4DCE+/P4DCE+II User's Manual
IMPORTANT: Always connect the power cord last and always remove it be-
fore adding, removing or changing any hardware components. Make sure that
you install the processor into the CPU socket before you install the CPU heat
sink.
!
2-2 Processor and Heat Sink Installation
When handling the processor package, avoid placing
direct pressure on the label area of the fan. Also, do not
place the motherboard on a conductive surface, which can
damage the BIOS battery and prevent the system from
booting up.
1. Locate the following components, which are included in the shipping
package. Note: VRM modules must also be installed (P4DC6 and P4DCE
only) - they are not included with the motherboard.
Retention brackets
(2)
Clips (2)
Screws* (4)
*These screws are to be used for
mounting the motherboard to the back
panel of a chassis that has four
mounting holes (as shown on right).
White pegs (4)
2. Insert the white pegs into the black
anchors. Do not force the white pegs
all the way in - about 1/3 of the white
pegs should be inside the black
anchors.
3. Place a retention bracket in the
proper position and secure it by
pressing two pegs into the retention
holes until you hear a *click*. The
clicking sound indicates that the peg is
locked and secured.
Two pegs in
position
One retention bracket in
position
Black anchors (4)
For chassis that do not have four
mounting holes, use the anchor/peg
assemblies:
Anchor/peg
assemblies