Chapter 2: Installation
2-5
Figure 2-2. Side and Top Views of DIMM Installation
To Install:
Insert module vertically
and press down until it
snaps into place. The
release tabs should
close - if they do not
you should close them
yourself.
To Remove:
Use your thumbs to
gently push each re-
lease tab outward to
release the DIMM from
the slot.
Note: Notch
should align
with its
receptive point
on the slot
Notch
Notch
Release
Tab
Release
Tab
Note the notch in the slot and on the bottom of the DIMM.
This prevents the DIMM from being installed incorrectly.
Support
The H8SSL-i2 supports unbuffered ECC/non-ECC DDR2-800/667/533 SDRAM.
Both interleaved and non-interleaved (single and dual-channel) memory are sup-
ported. See procedure on following page for installation order.
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum memory
: 8 GB of unbuffered ECC/non-ECC DDR2-800/667/533
SDRAM.
