Supero H8DGU, User Manual

Page: 25 / 72

Chapter 2: Installation
2-5
Figure 2-1. DIMM Installation
!
CAUTION! Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
2-4 Installing Memory
Memory Support
The H8DGU(-F) supports up to 256GB of DDR3-1333/1066/800MHz registered ECC
SDRAM or 64 GB of DDR3-1333/1066/800 MHz unbuffered ECC/non-ECC SDRAM
in 16 DIMM slots. See the following table for memory installation.
Memory speed support is dependent on the type of CPU used on the board.
Installing Memory Modules
Insert the desired number of DIMMs into the memory slots, starting with 1.
DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
Insert each DIMM module vertically into its slot. Pay attention to the notch 2.
along the bottom of the module to avoid installing incorrectly (see Figure 2-1).
Gently press down on the DIMM module until it snaps into place in the slot. 3.
Repeat for all modules.
To I n s t a l l : I n s e r t
module vertically and
press down until it
s n a p s i n t o p l a c e .
Pay attention to the
alignment notch at
the bottom.
To R e m o v e : U s e
your thumbs to gently
push the release tabs
near both ends of the
module. This should
release it from the
slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should align with
the receptive key point on
the slot.
Notch Notch
Front View