Chapter 2: Installation
2-5
Gently press down on the memory module until it snaps into place.
3.
Note:
1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It
is highly recommended that you remove the power cord from the system before
installing or changing memory modules. Please refer to our web site for memory
that has been tested on the H8DCL-i/6(F) serverboard.
Memory Support
T h e H 8 D C L - i / 6 ( F ) s e r v e r b o a r d s u p p o r t s s i n g l e a n d d u a l c h a n n e l ,
DDR3-1333/1066/800 registered ECC/Unbuffered ECC/non-ECC SDRAM. Only
interleaved memory is supported, so you must populate two DIMM slots at a time,
one per channel (see procedure above).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
T h e H 8 D C L - i / 6 ( F ) s e r v e r b o a r d s u p p o r t s u p t o
32GB of ECC/Non-ECC UDIMM or up to 128GB of ECC RDIMM in 8 DIMM
slots.
Figure 2-1. Installing DIMM into Slot
To I n s t a l l :
I n s e r t
module vertically and
press down until it
snaps into place. Pay
attention to the align-
ment notch at the
bottom.
To R e m o v e :
U s e
your thumbs to gen-
tly push the release
tabs near both ends
of the module. This
should release it from
the slot.
Top View of DDR3 Slot
Release Tab
Release Tab
Note:
Notch should align with
the receptive key point on
the slot.
Notch
Notch
Front View
