Chapter 2: Server Installation
2-7
Figure 2-4. Installing the Server into a Rack
Installing the Server into the Rack
Rails are attached to both the chassis and the rack unit. The next step is to install
the chassis into the rack. Find the two brackets in the rack mount kit. Install these,
keeping in mind that they are left and right specific (marked with "L" and "R"). Then,
line up the rear of the chassis rails with the front of the rack rails. Slide the chassis
rails into the rack rails, keeping the pressure even on both side. You may have to
depress the locking tabs when inserting.
When the server has been pushed completely into the rack, you should hear the
locking tabs "click". Finish by inserting and tightening the thumbscrews that hold
the front of the server to the rack (see Figure 2-4).
Locking Tabs:
The chassis rails have locking tabs that serve to lock the server into
place when installed and pushed fully into the rack, which is its normal position.
Warning:
Do not pick up the server with the front handles. They are designed
to pull the system from a rack only.
Summary of Contents for 4042G-72RF4
