Supero 2027R-AR24, User Manual

Page: 55 / 126

Chapter 5: Advanced Serverboard Setup
5-7
1. Unplug the power cord from the power supply.
1. Unscrew and remove the heatsink screws in the
sequence shown in the picture below.
2. Hold the heatsink and gently wiggle it to loosen it
from the CPU. (Do not use excessive force when
doing this!)
3. Once the heatsink is loosened, remove it from
the CPU.
4. Clean the surface of the CPU and the heatsink
to get rid of the old thermal grease. Reapply the
proper amount of thermal grease before you re-
install the heatsink.
Removing the Heatsink
Warning!
We do not recommend removing the CPU or the heatsink. If you do need
to remove the heatsink, please follow the instructions below to prevent damage to the
CPU or other components.
Installing a CPU Heatsink
1. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the retention mechanism.
2. Screw in two diagonal screws (i.e. the #1 and the #2 screws) until just snug
(do not over-tighten the screws, which may damage the CPU.)
3. Finish the installation by fully tightening all four screws.