19
Chapter 1: Introduction
1.5 Server Installation and Setup
The server is shipped with the onboard processor and the motherboard installed in the
chassis. Several steps are necessary to begin using your server. You must add memory,
mount the hard disk drive, and mount the system in place.
Unpacking the System
Inspect the box in which the system was shipped and note if it was damaged. If the server
itself shows damage, file a damage claim with the carrier.
Warnings and Precautions
•
Use a regulating uninterruptible power supply (UPS) to protect the server from power
surges, voltage spikes and to keep your system operating in case of a power failure.
•
Review the electrical and general safety precautions in Appendix B.
Adding Components to your System
•
Memory
: If your system is not already fully integrated with system memory, refer to Chapter
2 for details on compatible types of memory and the installation procedure.
•
Drives and Storage
: To add storage capabilities to your server, see Chapter 2.
•
Input/Output:
See Chapter 3 for I/O ports and connect them as needed.
•
Software
: See Chapter 5 for description and procedures for installing software, including
drivers and monitoring programs.
