SuperServer 7089P-TR4T User's Manual
58
CPU Module
Perform the following steps to install a PCI-E card in any of the eight CPU modules at the
front of the system. Power must be removed from the system (as described in Section 3.1)
when performing this procedure.
1. Begin by removing the corresponding CPU module, as described in Section 3.3.
2. Open the top cover after removing the screw that secures it to the chassis.
3.
Remove the five screws on the front riser cover and lift it up. If a GPU card is installed
in the CPU module you must also remove two additional screws and the GPU power
cable.
4. Release the latch and pull the dummy cover or existing PCI-E card out of the front slot.
5. Insert the PCI-E card to the riser card.
6. Reverse the steps above to secure the PCI-E card and replace the CPU module back
into the chassis. Make sure the four front hooks have been completely inserted.
7. Power up the system.