Supermicro SuperServer 6048R-TXR, User Manual

Page: 105 / 132

Chapter 7: BIOS
7-21
SATA/sSATA RAID Boot Select
Select SATA Controller to boot the system from a SATA RAID device. Select
sSATA Controller to boot the system from a S-SATA RAID device. Select Both to
boot the system either from a SATA RAID device or from an sSATA RAID device.
Please note that the option-Both is not supported by the Windows Server 2012/
R2 OS. The options are Both, SATA Controller, and
sSATA Controller .
sSATA Port 0~ Port 3
This item displays the information detected on the installed sSATA drives on the
particular sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
sSATA Port 0~ Port 3
Select Enabled to enable an sSATA port specified by the user. The options are
Disabled and Enabled.
sSATA Port 0 ~ Port 3 Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user,
which will allow the user to replace a SATA disk drive installed on this port without
shutting down the system. The options are
Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and
Disabled .
Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be con -
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.

Server ME (Management Engine) Configuration
This feature displays the following system ME configuration settings.
•
General ME Configuration
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features